Nano Ring Application - Hair Rebellion Uk

This nano ring application demonstration. Video has been produced by the hair training academy in conjunction with hair rebellion UK and is for fully qualified extension technicians only to ensure their clients receive the full potential of the 90 percent. Reduced visibility of this revolutionary hair extension fitting technique. Prior to application, reduce the thickness of the metal tip to ensure easy insertion into the Nano ring by squeezing them with your pliers, but only if required and being careful not to crush or split the tiny metal rod. We'Ve used blond nano rings for better visibility. In this video, as they really are so small, if we use the dark, you would not receive the benefit of the demonstration section. The natural hair is, you would normally do so when fitting microing extension methods, ensuring the sections are of equal size, width and depth. To ensure safe weight distribution on the natural hair, this may need to be slightly smaller section size than usual to get through the Nano ring, but not too thin, or the tip will put strain on the natural hair. If there isn't enough, in a section to take the weight, pull the hair section through the loop needle sliding the Nano ring onto the natural hair, just like a standard micro ring fitting leaving approximately 810 mil gap from the scalp to prevent tension. Lift the section of natural hair off to allow you to then place the metal tip through the nano ring from the underneath. This ensures that the bond is behind the natural hair, secure the nano ring by squeezing firmly with the pliers. You will see in this clip that the technician is using her left hand to allow better visibility for the camera, and, although the fitting in the initial stage, looks slightly too close to scalp you'll see how she has slid the ring down the hair shaft to the Correct position prior to clamping shot. You can see here the fitting from an alternative angle. The extension bond is placed behind the natural hair. Again, you can see the nano ring is in the correct position away from the root. The security of the bond is demonstrated here by pulling quite hard. Obviously, this is not recommended. You are now left with neat uniform bonds to remove the nano ring, simply unclamp with the pliers back into a circular shape sliding the hair extension and the nano ring out of the natural hair. If there is any tension, when trying to slide the ring out and show you hold the hair at the roots to avoid pulling so, you can see this hair can easily be reused. Here is a small demonstration of what not to do if the section of natural hair is too large. You will not be able to pull the hair through the nano ring if this happens, reduce the size of the section of natural hair remembering to reduce the depth. As well as the width to ensure even distribution, you can see the correct size section of the hair. Easily glides, through the nano ring, remember not to take a piece that is too thin as the nano ring and the extension bond will slide out also do not fit the nano ring extension on top of the natural hair. This increases visibility and defeats the object of the nano ring hair system. All the team at hair rebellion are highly qualified technicians and will be able to offer further advice and assistance if required. You