Revive Your Old Synthetic Wig Back To Life ~ Sensationnel Hair

Ladies, do you have an old wig? That is tired, but you do not want to get rid of it. Revive your wig and just a few quick steps, you're going to need a few supplies. Typical supplies are combs and brushes mild shampoos to make sure you clean the air but don't strip the moisture off. But the most important thing is a source of steam. You can use a garment steamer, like I have here, or a pot of water you're, going to start by pinning your weight to your wig head or mannequin, because you're gon na get in there and you are gon na brush all of the tangles. All of the kinks everything out of your unit start at the end and work your way up to the root. Once you have your unit all brushed out, you're gon na get some lukewarm water. We like to use a little apple, cider, vinegar, to really make sure any extra gunk and build up is really stripped off next, a mild shampoo. We have one specifically for weaving and wigs, but any kind of shampoo. That'S not gon na be too harsh on your wigs will do you're gon na dunk, your wig, fully saturate it and get it nice and wet and then really get in there and start scrubbing with your hands. Be sure not to be too rough because you don't want to rip or damage anything you just want to clean, it be sure to flip your hair inside-out, especially if it's a lace, wig and really clean. Your leaves next put it back on your mannequin again separate it into section. The key to reviving your wigs is working in small steps and sections. Now, for my rollers, I just really want to refresh these curls that were already there, but maybe just a little worn out. So I'm going to section off the hair the way I would like for it to fall rollers I have here, have a metal inside. That'S going to be important for the steaming of the next step, the more rollers you use, the tighter your curls would be the rollers that I have have a metal inside, and this is going to be important on our next step. As this unit is a synthetic unit, the heat from the steam will form the curls around the rollers and basically melt it into place. The heat from the steam is what's going to reshape the hair, but not damage the hair use the steam on the hair. For about four to five minutes, ideally you will let to let this dry overnight or for a couple of days, but if you're in a rush, a few hours will do. As you can see, there are some gaping that you can see the tracks, but separating your curls once they've begun to dry is really gon na bring that fullness back by separating these with your fingers, and that comb is gon na ensure that you don't get any Extra frizziness that you really weren't anticipating, allow your units thoroughly dry before wearing it, and there you have it. Ladies you've restored your unit that you weren't ready to get rid of or replace just yet