How To Take Head Measurements For A Custom Full Lace Wig

Hey YouTube is glam goddess wigs and today we're going to take custom head measurements for a full lace. Wig. What you'll need is a measuring tape. Any kind of measuring tape will do i like to use these. You need a stocking cap and i use a knee-high, and this is optional, get your camera okay. So the first step, which is very important, is to figure out how you're going to wear your wig. Underneath your way cap, you can put it in braids or corn roll it. Personally, I just like to put it all back, and I do this just like it if I was wearing away so I put my knee high on and tuck my hair underneath the knee high in the back twist and tuck for me, and I try to get All of my hair, underneath that wig hat with the end, I just pull it back to my hairline and tuck it underneath okay, so now you're ready to start your measurements grab, your measuring tape and the first measurement we're going to take is the circumference over your Head so find the beginning. For me, it's where the silver tab starts and simply take a measurement of your whole head. I like to start from the back and meet it around to the front. My circumference turns out to be 22 and a half, as you can see right here, 22 and a half. The next measurement is from front to nape start a little bit before your hairline. As you can see me pointing right there and go straight back until your nape I like to go to where I don't have any more hair left and my measurement for a front to Nate, it's 15 and a half. The third measurement is from ear to ear across the front, so you're going to measure from the top of one ear across the front to the top of your other ear, and my measurement is 13, as you can see right here. The fourth measurement is the nape. Just measure from one side of your knee to the other and my measurement is 4.5 4 and a half the fifth measurement is from ear to ear over top, so again go from the top of one ear to the top of the other and across your head. The top of your head, my measurement, is 12 and a half, and the last measurement you need to take is from Temple to Temple from Temple to Temple around the back and an easy way for me to figure out where your temple is is to line up The outer portion of your eyebrow and just draw a line and, as you can see, I had to adjust mine. My temple to temple measurement is 15 and a half and you're going to need to take all six of these measurements at least three times. To make sure that you have them down properly, you would be surprised. The last thing which is optional. It'S simply to take a picture, a clear picture of your hairline. Then i can try my best to make the hair line of your custom unit as close to your natural hair line as possible, and so that's it you're good to go. Thank you for watching bye, bye,