How To Pluck Your Part For Beginners (No Tweezers)Detailed| Shainajay

What'S good guys with Shana J and then back with another video, and today, I'm going to show you guys how to customize length blockier synthetic wig part without any tweezers and without really doing any work at all. So what you're going to need is a personal brush or a Denman brush, and you can use actual hair wig pins that help you hold your weight on the mannequin head, but I just use the thumb times because I didn't have those. I used a $ 2.99 mannequin head from the B supply storage, the styrofoam and disposable, and then you're gon na need either powder or some type of concealer and a brush to blend it out. So I'm just taking my wig and putting on my styrofoam mannequin head as you can see, the part right now is very skinny. It doesn't look as bad on the mannequin head, but I was looking pretty skinny on me, so I'm just gon na separate the little part that I'm gon na be working with and pin it underneath that so that the pins don't get in my way. So all you're gon na do is. I have nails. So it's a little bit easier for me, but even with your fingers, just take the little strands that are closest to the part and that's where you're gon na start. So you want to do only one or two hairs at a time when you're pulling and as you can see, I just wrapped it around my index finger and then I did a slight tug on it and it came right out. So if you pull on it, see right there, it didn't come right out, so that means I had too many hairs. You want to only take one or two at a time. So, even if you don't feel like you have a lot separate it into an even smaller section, wrap it around your finger and pull, and it should come out on the first try. If you pull too hard, you will rip your lace and your. We could either fall apart or just have holes in it, which is not a good Lexus. So don't do that so you're, just gon na go up and down back and forth on the part and pick the sections where you want to make it a little bit wider. For me, I had some guidelines because this is a middle part only way. So there were some tracks right along the sides of this part, so I knew where I had to stop. But if you have a three part wig or a full lace, wig, it's a little bit more difficult and you got to be very, very careful, so synthetic wigs are a little bit tougher I'd say so now, I'm getting to the edge where that track is and I'Ll show you guys what it looks like so since this is middle part only. I can see that the track is right there, which means that I have to stop, because you want to leave a little bit of hair to cover that part, because you don't want that to be showing. And then you can just go back and see any parts that still look too skinny or aren't matching the guidelines over here. The rest of your part is - and you can just go back and plug that out too so now your part should be looking much better. Nice and wide and natural looking. This is what the inside of the wig cap looks like. I just wanted to show you guys what I meant by it's only a middle part, and this is how much hair came out from my plucking, so not a lot, but it does make a difference. And now I'm gon na take my makeup brush and my concealer. I used la girl Pro concealer because it's easier because it already has a brush on it, so you can just kind of paint it on and you can control how much comes out at one time. So I just brush that onto the part to make it a little bit more Brown which will help it match your scalp and then I go in with my brush to blend it out and make sure that it's not on the hair. So now it's looking much better and you guys can see that it looks a lot more natural. As always. Thank you guys so much for watching make sure you like comment and subscribe and follow me on instagram at the chainage. A and I'll see you guys in my next one