How To Install A Full Lace Wig No Glue/Tape/Sewing

Hey welcome back to my channel if it's your first time welcome and be sure to hit the subscribe button for more updates so for step, one I'm using a dime sized amount of got ta, be glue, setting glue to lay my edges, nice and flat first step. Two I'm using a rat tail comb or you can use a brush slicked back any strands. This will allow my edges to lean needs and avoid them from sticking out from underneath my wig now for step, three use a head scarf to tie it down your hair. Make sure you slide your scarf back a little bit as I just did and make sure it's also very snug. Leave this on for a total of 20 minutes for step, four take a free scarf. Your hair should be nice and flat, but got ta be glued styling gel should have dried and have become a little stiff. As you can see, there are some flakes in my hair from applying more than what I needed now for a quick side. Note I'm going to be using, got ta, be glue, styling glue and it is completely safe, it's great for lace closures and can be safely removed, removed by using water. I have not lost any hair from using this product and if you want to save a dollar as an alternative, you can buy the Harmon face value brand, which works exactly the same. So for step 5. I am using a net on my hair and this is just making the braids super flat. I have all this extra net hanging in the back as you can see, and I'm just going to take two pins and just pin it to make sure that it's super flat and not bulky. You can skip this step if you don't usually like wear nets or stocking caps under your wig is totally up to you so for step. Six. This is the wig that we'll be putting on today is from the company Luffy wig. I attached an elastic band on to both sides of the lace wig. As you can see, you will need to do this to make sure that both parts of your lace by your ears lay flat for more of a firm hold use. The elastic straps in the back to tighten the wig before you put it on. If you have any Bowl elastic straps on the wig, a more natural look, you can totally bleach or not. If you would like for this way, I did not bleach the knots, but it's highly recommended for a natural-looking scalp, so I will be doing it next time and now for step 7 put the wig on and prepare your baby hairs by combing them towards your face. Now get sure I got a big little styling glue and place a small amount on your finger now apply it to your baby here, as I am doing now, and be very careful with this, because you don't want to put too much or it will flake up During the day and for a more firmer hold blow-dry the section before I move on to the next section, it will make sure everything is dry and nothing lifts up throughout the day. You you you and now just repeat the same exact steps as you did on the left side to the right side, and you are almost there with completely installing. Well, I hope you guys enjoy the video if you have any questions or comments. Please comment down below. Remember guys to follow me on instagram, at Simone Charisse and on snapchat at Sim City, one to four and guys. Also, please subscribe bye, guys,