How To Cut Bangs (Beginner Friendly) + Frontal Wig Install Ft Vshow Hair

Foreign I'll be installing a wig from V show hair inside the package. I received the frontal wig, a necklace and a wig cap. The wig that I received is a 13x4 transparent, frontal, 26 inch, wig foreign, as you guys can see from the title and how the wig is styled on my client's head. I will be showing you guys how to cut a bang in this video. I already placed the bowl Cap on my client's head now, I'm just making a dotted line, so I can know where I want to lay the lace. Thank you, foreign's hairline. You want to make sure that you spread it evenly, so it can dry. At the same time, thank you once the glue is clear. You'Ll know that it's completely dried and then you can apply the second layer of glue foreign foreign foreign, as you guys can see for this bang hairstyle. My client didn't want baby hairs at the side, so only The Sideburns are out as baby hairs. When you're cutting the side of the lace off, you want to be sure to cut it in a zigzag motion, because there won't be any baby hairs to cover the lace. Thank you, foreign foreign, when you're finished, cutting off all the lace, you're going to use the makeup closer to your client's skin complexion and cover the lace that is showing foreign after you've done that you're going to use a holding spray of your choice and spray it Across your client's hairline then apply an elastic band on top, while the elastic band is melting. The lace into my client's skin, I'm going to start to style the hair. The product that I am rubbing into, my client's hair is Biosilk. I put a little bit into my hand and now I'm just rubbing it throughout the entire wig foreign. This is the result of the lace being melted. While I was styling my client's hair now, I'm just gon na hot comb and mold the hair into place before cutting the bangs for the baby hairs. We were going for a messy natural look, so I didn't use any moves to enjoy. The first thing I did was curl. The baby here is with my pencil red flat iron, and now I'm going to use my gotobuku spray and my Edge brush and lightly spray, some on the side that I'll be using before applying it to your client's Edge. You want to make sure that it's dried a little bit, so it won't be dripping all over foreign. If the brush is dried correctly, it should automatically stay down and be molded once it's brushed foreign with cutting the bangs, but before I cut them, I want to make sure that the bang is flat. So I'm just going to run my hot comb through the top on the bangs. We wanted the two ends to be longer than the middle, so that's the first thing that I'll be cutting in a diagonal line, because it's my client's first time with a bang. We didn't know what length we wanted it to be, so I did start off cutting it at a very long length. Now I'm going to cut the bang up to where we think it'll look best now, I'm just flattening the bang and combing it out to see. If this is where we want it to be foreign, as you guys can see, the bangs still ended up being too long. So now, I'm gon na cut it a little bit above her eyelid foreign. The scissors that I'm using to cut the bang are regular art Scissors, because these are the scissors that works best for me. Now that I've found the length that looks best on my clients, I'm just using the scissors and making sure that everything is straight. The sides that are supposed to be longer at the end of the bang, we did end up cutting them a little bit shorter, closer to the length of the bang, because that's what looked better foreign? This is the finished look. I hope you guys enjoyed watching and remember to like comment and subscribe continue watching for more videos of the finished look foreign