How To Make A Triple Layer Satin Hair Bow - Theribbonretreat.Com

Cut out your ribbon to three pieces, two pieces you're going to cut out to about 11 inches and then the third piece is 10 inches and you can make these bigger or smaller, as you'd like so taking one of our longer ribbons. So take your ribbon and we're going to make the beginnings of a bow tie, bow so overlapping the two ends and then bring it to the center turn it over, so that those ends are on the back and then we're gon na turn that ribbon as much As we can and then once you've got it where you want it in the center of the bow, take your pin and thread it through like that and then once you've done, that go to the end and push the top of it. The bow in and if you push it in too much, it will end up looking like like this and we'll have a totally flat line. We don't want that okay, so when you're pushing it in push it in so this end is still kind of fuller and then do the same for the other side and then do the same thing for your other two ribbons. Have your needle and your thread ready we're going to stack these so take your two bigger pieces and place them up and place them to make the shape like a bow. You got the four right there and then taking your third one place it in the center and then taking your needle in your thread, come through the back to the center and then once that's through we're going to take the pins out and wrap this bow. And then accordion fold and tighten as you rap keep tightening until you there's no more give coming to the back, take a couple stitches and open it up and then just move things around alright and that's how that looks so cute huh. So that's how you do the bow and now we're going to do our Center cut out a piece of your ribbon. This one is about six inches and just make it into a knot. So once your knot is done, just take your hot glue gun place hot glue on the center of your bow and then place that not on that hot glue and then we're just going to wait a little bit for that to cool down. And while that's cooling down, let's turn it over to the back and we'll take our line, clip and place hot glue on the back of the are the top of back and then place it on the back of our bow. Okay, now opening up the clip, I'm gon na place a teeny tiny bit of hot glue on there and bring this back. I'M gon na want to pull too hard. So then it will pull on that knot and move that knot. So because of this, this ribbon is a lot bigger, there's gon na be like. I just want blue it a little bit right here, I'll, let it all stays down and then take your scissors and we'll clip off this excess ribbon right here and take your lighter and just seal that really quick. So it doesn't fray and then opening up we'll put a little bit more hot glue on and bring this side over, move that on and then again we're gon na have to put some hot glue, not a lot just a teeny tiny bit to help that just Be flushed and then taking your scissors, we're just going to clip off the rest of this excess ribbon and then take your lighter and do that and that finishes this is super super cute. Oh