How To Change The Part Line Of Your Hair Topper

Hey girls today, I'm going to show you really quickly how to change the part on your silk bass topper. So it is a lot easier than you think and trust me you're gon na be like well! Is that all so, when you receive a topper, it normally will come to with a center part. So you can see here the silk top this one I have used before so is a little bit messy, but normally the line will be quite straight similar to this. One, but I've moved that one to the side too. So when you receive your topper, if you'd like to change it, so you can do a right side, part or a left side part so the silk base here. This is the area that you have to change. The part line so you've got four inches white to move the part so in this bit here, that's where you get the silk fabrics. That'S going to give you the scalp light. Look in that section so to change the part line you don't actually have to completely wash the topper. All you need to do is a spray can of clean water and you just spray on the pant line and then with a rat's tail comb. What you do is you comb the hair back now, let's just say, I want to put it on the right side, so, once I've combs at bat, I can probably just put a little bit more water on it. Once I've combed it back, I'm going to locate roughly where I want the part line and with the pointy end of your coin, you just make a little line and then you simply brush the hair out to the site. So this is how you can make that part line. Look a little bit messy. So it's not a hundred percent perfect or if you like that straight line, look you can achieve it. It probably just takes a little bit more time and care to move the part line, so I've just moved this part, so it was about here and now it's over to one side and I'll. Just comb the hair be careful with a fine-tooth comb when you're combing the chopper s route. Alright. So once the part line is where you want it to be, I'm added a right side path. You can put it on to a mannequin head, but this is not necessary when you put it on a head, it just gives it more opportunity to molt to a hit grab. My blow-dryer, if you don't have a mannequin hit, all you need to do is just hold the top up, turn the blow dryer on and then just and that's it so once it's dry that basically drying the hair, it sets it. So it's going to stay on that side and then you just place it on as you would that the part line has shifted. So here we go. This is the same. If you want to add that little bit more volume, you want that lift in the front. All you do if you want more lift at the front of the topper mind's quiet like straight down, you can just spray the front and then comb the top hair back. This works best on a mannequin head and even with a round brush, and then you can even place it upside down. Grab your blow-dryer, trying it backwards will give it that little bit of lift at the front there. You can see that so it's not as straight, but it's got just that little added bit of body at the front. I hope this is helpful and I'll see you in my next little video. Thank you. Bye,