All Over Hair Color – Single Process Color Application With A Bowl And Brush

We'Re going to begin by draping the gas using a towel underneath to protect their clothing from color, we're going to go ahead and apply a barrier cream around the hairline, while i'm sure we're capable of painting between the lines neatly, it's always possible to get a stain Or two next we're going to section the hair into four sections: go ahead and measure and mix formula number one for the base outline the first front section now go ahead and apply to the base using a quarter. Inch diagonal back parting work from the top of the section to the bottom, bringing hair away from the face repeat the color application on the other front side notice how we are painting both the top and bottom of the section. This is a huge time. Saver move to the back and repeat the same procedure using horizontal partings work from top to bottom. Let'S go ahead and mix formula number two for the mid shaft and ends. We always want to use a lighter and slightly warmer formula as porosity is high in these areas. Begin in the bottom back section where we left off take the same quarter, inch partings and apply color from the mid shaft to the ends, use a squeezing technique with your middle and pointer finger to evenly saturate the hair with color time to repeat the color application. On the other back section now, let's go ahead and release the side sections by bringing them down again. Take quarter inch sections this time from the top, applying the color away from the face time to repeat the application. On the other front side, hot tip cross check to ensure saturated application, we're going to set a timer according to manufacturers, directions, let's go ahead and condition rinse and then we'll style it as desired. You