Middle Part With Bangs | Using Synthetic Clip Ins | Sensationnel Textured Clip Ins | Kinky Straight

Hey guys, it's your girl, lisa renee, and thank you for tuning in to elise renee tv. I am back today with another video in today's video i'm going to be installing these clip-ins. I have already installed these clip-ins before so go ahead and check out that video. It'S on my channel, alright! So right now i have my hair parted in three sections in the front and in the back i have my hair braided. So what i'm gon na do is go ahead and install the clippings on my cornrows and just do that until i get to the top do all right. So, as you see here, i am unbraiding this section and what i'm gon na do is go ahead and unbreak this and then i'm gon na straighten it out piece by piece and then insert my clipping in between so that way it can blend in with the Hair, the flat irons that i'm using are from revlon and i have already sprayed heat protectant on my head before i started doing my hair, so my hair is protected while i'm doing this alright. So here i am just inserting this clip in. It is the three inch clip in it has two clips on it. All i did was part this section of hair in half, and i did it in an angle so that way, this clip in would be uh hidden. That way, you wouldn't see it in the front or in the back at all, it'll be undetectable, and for this side i'm just going to go ahead and do the same thing. I'M just going to go ahead and straighten this section out and then i'm going to part it in an angle and insert the three inch clip in my all right so right here, i'm actually going to go ahead and embrace this and try to do some bangs. I haven't cut my own bangs in forever um. So wish me luck, i'm not a professional or anything um. So what i'm just gon na do is go ahead and just straighten this out. So that way the hair can be as even as possible. Before i cut it, so my bangs aren't like lopsided or anything like that, so i'm just gon na go ahead and straighten it out and now i'm just gon na go ahead and cut it. I'M gon na i should have started a little bit like smaller, but you know i tried here, i'm just trimming them and they don't look too bad like they actually look kind of good and now i'm just pressing the flat iron on them. So they can lay down flat. I think they turned up pretty well so kudos to me. So now i'm just gon na go in and fix up my edges on both sides. So if the wind blows, you know, my edges aren't looking too crusty and dusty and i won't be embarrassed so i'm just going in with some jam and fixing my edges up, because i don't have any edge control all right. So this is the final look and i do love how this turned out. Don'T forget to like comment and subscribe and also check out the first install