Double Loop Hair Bow With Tails - Basic Hair Bow Tutorial Simple Hairbow Supplies, Etc.

Hi this is one from here Bose today, I'm going to show you how to make a double loop hair bow with tails. You will need 36 inches of 7/8 inch ribbon, aligned, alligator clip a jumbo clip needle and thread hot glue scissors and a lighter okay. Let'S get started first, we will take our ribbon and we are going to start with the tail. We want to make a four inch tail, so we're going to take a measuring tape and measure four inches and then put our fingers right at the top of the four. Then we're going to start our loop and it's going to go all the way up to the eighth and then we're going to bring our ribbon back down to the four. So your tail is going to be four inches long and then, from the start of your loop to the end of the loop it'll, be an eight okay, so we're right! There then we're going to loop our ribbon again up no measure again and make sure that it's four inches long and then we're going to bring it back down again we're going to go back up and now this last loop instead of leaving it like this run Across this loop over to the left a little bit, okay, then we're going to get our jumbo clip and slide it right down this Center. I'M going to make sure this is even left to right and you can measure it with. Your measuring tape should be about two inches on the right and measure two inches on the left and just like this, a little bit over to my right a little bit. Okay! So now that we have this now, this looks a little weird, but it will turn out. I promise okay, so then you're going to get your needle and thread and go back underneath in between the Jumbo clip up and down and through the loop then bring your ribbon earth. Excuse me your needle up under the ribbon then over under and over okay. Then we are going to hold on to your thread and hold on to your ribbon and you're, going to pull wrap that up and around one more time while we take it off. Okay, know this: take your needle and just kind of poke it through the ribbon. Real quick and that'll help you to be a little pull that out easier. Okay, then we're going to just wrap your thread around the ribbon a couple more times, and then you can secure it in the back, get your scissors and cut okay. Now. The reason why we did this loop funny in the front is because that way you can pull it down a lot easier. You just left to the left. You pull up to the right our edge and here take our ends: fold them in and cut on an angle, get your lighter and seal okay. Once you have that done, then you can go ahead and just fluff your loops, like you want it, and then we can turn it around to the back. I'Ve had some hot glue and then add your lined alligator clip and then for the front. If you would like to you, can do it not or you can do a rhinestone button Center, I'm going to do that today. So you just take your rhinestone button, there's a shank on the back and you can just cut it. Get some hot glue put that in the center and then put your buttons down on the center, and that's it. Thank you so much for joining us and have a great day.