Mini Cheer Bow Tutorial - Hair Bow Making - Diy - Ribbon Creations

Hello and welcome to enchant and Sparkle crafts. Today, I'm going to show you how I make these miniature cheer buzz very cute, I'm using one on 1/2 inch width ribbon and I need to cut 14 inches. So I've got this I am going to. We need to make sure that everything it's not facing this way. It needs to be facing away from us, so little pat replacement, if you have a patterned ribbon, is correct. So we need to do just fold it towards its like this and then cross out there. Try and keep it quite spiky at the top like this, make it safe up about an inch and a half yeah, find you sense by pulling it out and then push that back in try and keep it so spiking close together. She come down man. It gets difficult and quite tricky to hold it that way, and then I stitches three dude big thick stitch. Is it really the monster big uns, and then I go back up against the top, so so back up, still big stitches and then I'm just going to pull my creates a fold that we're gon na wrap it round again wrap him and pull a little secure. A few stitches in just sew the thread holes three threads tight and then snip off next, I'm gon na cut my spikes just fold in half make sure is either heat seal the ends thanks Anna next I'm going to clip lining my clip with nine millimeter ribbon Right that my camera decided to stop recording, so all I did after writing. The clip was I'd must enter straight for the round the middle, just basically glued on little bit around and believed it on the other side. Again. So sorry that cuts out that, but you got the main part of the video before it dead. Thank you for watching my how to make a mini cheer bar tutorial. If you enjoyed this video, please subscribe for more videos come in a regular basis and please like it. Thank you very much.