Flawless Closure Wig Install | Loose Wave | Yg Wigs

Hey guys welcome back to another video, i hope everyone is doing fabulous today. We go be good, big up so guys. Today i will be installing this wig from yg, wigs and first off. Let me say: i love the packaging, it's very elite, so i'm going to show you what i got in the package and give you some info on the hair. Before we begin, remember, leave a like on the video subscribe to the channel guys this unit is their 5x5 closure. Wig, it's a loose wave here and i got it in 22 inches all the details for this here will be in the description guys so go ahead and check that out. As you can see here, the hairline is pre-plucked, it's pre-bleached and it's a 5x5 closure, meaning or install is going to be very quick, very easy. It also comes with this band on the inside so that you can wear this glueless now. Just to give you a closer look on the 5x5 closure guys, i love that they already pre-plugged the part, because that sometime is the hardest part on the unit to plug. So, thank you, yg wigs for doing all the work for me, and these are just what i got guys. These earrings are too cute and of course i got a wig cap, so let's get right into the install. So the first thing i want to do is i'm going to plug the hairline a little bit more. This step is not necessary at all. It does come pre-plucked for you and ready to wear, but i i have a special hairline, so i just want to pluck that a little bit more, so it fits even more perfectly. So while i do that, let me give you some details. Are my thoughts on the unit so far, so this is a loose wave, a unit right, so it's curly. I love the curls of the unit coming straight or the pack. I really like that it didn't have much of a smell to it. Also. I love that there was a minimal shedding okay, so now that i've plucked it to my liking, i'm just using my hot comb and i'm combing everything back applying some heat, so it's laid in the front so that i can start laying the lace - and this is The lace spray that i'm using today guys, i am just spraying that over the perimeter of my forehead, because it's five by five, so not a lot of work, and i let that just air dry down a bit and then i'll just lay the lace. On top of that, one step that i love incorporating in my installs is just making sure the front of the hair is flat because coming out of the package, it may be a little you know bumpy here and there. So once i use my wax stick and then i go in with my hot comb, as you see i'm doing here, it just makes the top lay down so nicely. Of course this is a curly unit. So if you like yours not to be as flat, then you can skip this step. It'S not required, it's not mandatory, so you can skip this depending on how you like to wear your unit. Now that i have it laid nicely, i went ahead and cut the lace, all the excess lace, and sometimes you need to go in a little deeper where the lace starts on either side of your head. Just to make sure there is no bulging where that is so that's what i'm doing here, i'm just going in as much as i can to the sides and kind of fine tune to make sure there isn't any bulging lace right there. Then i'm using my got to be spray. You already know this step. I use it to kind of seal the lace and further melt it into my skin. I'M not going to tie down the hair again, i'm just using my blow dryer to dry that down, and this is what the curls are looking like guys. I haven't done a thing to the curls and look at that. It is so beautiful and of course you see. No baby hairs are necessary with this unit because the lace is just that good. But with my curly units, if you're new over here, i like to add baby hairs to my curly units, i think it gives that vibe that i always look for in my curly units. So i'm going to be using my rapid shine, setting lotion and kind of make some baby hair some soft baby ears, so i was so in love with the natural loose waves of this unit. I didn't want to disturb it too much. All i wanted was to redefine the curls, so i'm using my curling cream to accomplish that. I just lather a small amount in my hands and then work it through in sections on the unit so guys, i'm so happy. I decided to use a curling cream because i think it just enhances the natural curls on the unit the loose wave without kind of weighing it down. If i were to use like water or the mousse, i just think it was the perfect choice so yeah. That'S basically it for the install guys. Let'S get right into the final look guys. I am loving the curls on this unit. The lace has just disappeared into my skin. So, thank you so much yg wigs for sending this lego over all the details, for it will be in the description of the video guys go ahead and check it out, leave a like on the video subscribe. If you're not already subscribed and i'll see you in the next one bye guys, you