Best Glueless Ready To Wear Wig | No Bleaching Or Plucking!! Ft Hair Vivi

Welcome back to my channel in this video i'll be installing a wig from hairvavvy inside the package i received a 13x6 straight frontal wig, along with some hair clips and an edge brush. This wig was installed exactly how it came. It already came with the middle part. The hairline was pre-plugged and the knots were pre-leached. All i did was pull out some baby hairs and one curled the hair. So for this video i will be showing you guys how i prep my wigs for install. So, for this part, you will be needing a canvas head, a hot comb, a wax stick and a tail comb. The first thing that i'm doing is taking some hair to cover the tracks. In the back of the wig, i already molded the left side of the wig. How i want it to be so i'll, be showing you guys exactly how to do this on the right side of the wig. So the first thing that you're going to do is take out all the hairs that you want to use as baby hairs for hotcoming this wig. I used the tailcomb and parted it in three sections, because it isn't a full frontal, meaning that the part that i started off at there are tracks there. So it made me start a little bit higher than i normally would on a full frontal wig, once you've sectioned out the hair that you want to hop on you're, going to place the wax stick on the hair and hot comb, starting from the roots you're going To do the same thing for the next two sections, once you finish: hot combing, the side flat you're gon na push back the hairline with the hot comb, so it can give a widow's peak effect. This is what the wig should look like when you're finished all baby hairs, and everything are neat in place. Before this install. I will be attempting to install it with no glue, except for the cap. I already placed the cap down using got to be glued free spray, so the first thing that we're going to do is cut the lace-up that isn't needed for this insole. The wig is already secured with the elastic band that was on the wig. You don't have an elastic band on your wig. You can simply use the regular black elastic band that we used to secure the lace and sew it on the inside of the frontal so for glues and stores. I always recommend using hd lace, so it won't be as visible because of how thin it is. So after you've cut off all the lace you're going to cut and curl all the baby hairs that we pulled out in the previous steps when styling the baby hairs. You should be gentle when sweeping them, because if you don't, then the baby hairs will slide under the lace, as you guys can see. If you look closely when i'm swooping this baby here, they do begin to move under the lace, and then i have to use the edge brush to lift them over. So once you've finished sweeping all the baby hairs. You can use your five to six wrap strips and tie them down until they're dry for the styling process of this install. I did do some big wand curls that i'll be combing out after i finished hot combing, the hairline you, if you look at the side of the wig, you can see that the lace does not match my client's skin complexion. So after i outline the part to make it look sharper, i will be applying some makeup to both sides of the wig. So now i'm just going to slide my tailcomb under the lace to show you guys that this wig install is completely glueless. This wig was honestly a 10 out of 10.. It holds curls very well and it came pre-bleached and pre-plucked. I hope you guys enjoy watching this video. This is the finished look and thank you guys so much for watching you