Crown/Halo Braid On Lace Front | Frontal Wig Install Ft Hermosa Hair

Foreign welcome back to my channel in this video I'll, be installing a wig from Hermosa hair inside the package I received a wig, some lashes, an elastic band and a wig cap. The wig that I received is a 13 by 4 26 inch, 220 percent density. Deep wave wig, as you guys can see from this clip that I'm showing you that the knots are really small and the hairline is somewhat pre-plucked. Even though the knots on the wig were super small, they were pretty hard to bleach. So some of the knots are still visible after I've reached them for this insole. My client wanted two baby hairs on each side and a braid across the front of the wig right now, I'm just positioning the wig to where I want it to lay on my client's head once I have it positioned exactly where I want it. I have her hold the two sides of the wig, so I can make a dotted line, so I can know exactly where I want to place the glue now, I'm just cleaning my clients hairline, also that when I apply the glue the glue can stick properly on A clean surface foreign I used three thin layers of glue once the first layer is dried. Clearly I then apply the second layer and then the Third, when you're spreading the glue, of course, your client's hairline. You want to make sure to spread it evenly so that it can dry all at the same time, foreign as you guys can see the lace that I'm installing on my client's head is an HD. So I didn't apply much makeup to the lace until it was on her head, so I can see what matches her skin complexion better foreign onto the glue. I make sure that I stretch the lace as much as it needs to be so that it doesn't end up with any rolls in it once I'm finished, applying the lace into the glue from Air to air. I have my client hold the both sides, just until I finish cutting off the lace from the middle of the wig foreign. You will see that I'm using the scissors and cutting the lace in a zigzag motion. This will make the lace appear less visible. Once it's melted to my fine skin complexion, finish cutting off every section of lace that needs to be cut off. I use a thin layer of glue and place it on top. This will not make your lace sticky. If you use the right amount of glue foreign foreign foreign, when I did my plucking tutorial, I explained that I don't always predict where the baby hairs go exactly on my client's hairline correctly, and this is an example of me not placing it at the right place. The baby hair, the Sideburn baby hair is a little bit too high for my client's hairline, so I have to shift it down a little more. The first thing I did was cut around the air like I normally do and cut off all the lace that needs to be cut off, since the baby hair is higher than it needs to be. What I do is take some of the hair. That'S supposed to be with the rest of the wig and pull it down to make a new Sideburn baby hair. Once I have the baby hair as low as I need it to be, I then take some of the pears from the Sideburn Edge and place it back with the rest of the wig, so that it cannot look as high as it did before since we're bringing In hair from the rest of the wig, it may not be plucked to your liking, so you can then thin out the hairs as much as you want to fit your client hairline foreign, as you guys know. By now, I use godspeed glue, gel and cream of nature, moves to suit them and tie them down until they're completely dried foreign. Thank you. Foreign foreign s are dried. I used some bio silk and placed it on my client's hairline before hot coming in foreign foreign. The entire hairline I then use some gel any gel would be fine and place it at the root of the front of my client's hairline. This is where the braid will be. I used a small amount of gel just so the braid can have a neater look. Look foreign for the braid that I'm doing across my clients hairline. I only parted a small amount of the front tool to braid, because I didn't want it to be a super thick braid covering most of my clients, hairline. Thank you, foreign foreign. As I reach to the end of the braid, I didn't braid it all the way out, but I did braid it just enough so that it can reach to the side of my client's, wig foreign, the braid at the side of my client's. Wig I took a piece of hair from that same side and placed it in a ponytail with the braid. This will keep the hairstyle neat and keep the braid hidden. At the same time after I completed the braid, I then used my angled brush and the makeup closest to my client's skin complexion to outline all the parts. Thank you, foreign. This is the end of the video. I hope you guys enjoyed watching and let me know what you guys think in the comments.