How To Make Accent Bows For Stacked Hair Bows - Hairbow Supplies, Etc.

Hey this is one from here Bo supplies, etc. Today, I'm going to show you how to make your accent bows for your stacked, hair bow. You will need 7/8 inch ribbon. This is 5 inches long. Then another piece of 7/8 inch ribbon, that's 3 inches long and then you will net need another piece of 3/8 inch ribbon. That is two and a half inches long. You need scissors hot glue and lighter ok. Let'S get started first of all, you're going to take your 5 inch ribbon, you're going to fold it in half and crease the edges really really really good. I'M also going to take your lighter and you're going to seal the edges of your ribbon. Okay. So what you're going to do is open that up you see the crease right there get your hot glue go straight down on your ribbon. There you were going to fold your right side in and then your left side in and let that sit for a moment. This is a tuxedo bow. This is just a really really small one. Push that down real good. Okay, then you're going to flip it then you're going to fold it inwards towards you, make a crease there put some hot glue right down in the center and fold that up and then hold it just like that. Okay, once you have that pinched, then you're going to take this edge and fold it back towards the middle, then you're going to get hot glue. Put that down there and then fold this back again and hold it real, firm. Okay, then you're going to get the other edge and fold it back and get some hot glue and then fold this back again. Okay, there is the first part of your bow. Then you take your second piece: that's smaller get your scissors fold, this edge back cut. It on the angle get your lighter seal that fold this edge back here, cut it on get your lighter, then you're, going to fold this in half here and then you're going to bring this up. Your Center is just out here. So that's where your Center is you're, going to hot glue this on to the bottom part here, so it there's your Center, put some glue on the top here fold that in half again and then put that right there on your bow, just like that. Okay, now that we have this part, then we're going to get our three-eighths inch ribbon seal your edge, we're going to put some hot glue on the very tip of the top and then put your ribbon here on the top paper and hold that down. Then you're going to wrap your ribbon around the bow a couple times. I couldn't know that we know what our back is: trim it get your lighter and seal, and then you will put a little bit of hot glue on the back end of ribbon and then just push it closed and you will flip your and then you have This done because what I do is, I will get just an alligator clip and then open up this bow a little bit and then flip out your ends towards you just a little bit, and that is how you make an accent bill for your stacked here. Both thank you so much for joining us and have a great day.