How To: Install Wigs Without Cornrows (Versatile)

Hey guys, I am back with another video this time, I'm going to show you guys how I get my hair under wigs without any cornrows. One of my subscribers actually asked me to do this when I had did my Leola wig review so here it is, I hope you guys enjoy. So if you want to see how I get my hair under this and this with absolutely no cornrows stay tuned. So I'm starting off on dry hair today, in the event that I'm throwing my hair under awake the day of wash day, I will use Africa's best hand manis to deep condition, or even Body Works, natural, deep conditioner, whether my hair is wet or dry. I use came to leave in for this process, so I'm just going to start off by sectioning off my hair and I'm just finger detangling a little bit wetting my hair, throwing the leave-in in my hair and then I'm going to pull my hair out and braid. It now you want to be sure that you are not braiding. Your hair super tight at the root because you're going to be pinning these braids, so you want to make sure it's loose, so it doesn't cause tension around your scalp and you're. Just going to repeat this process all over the back half of your head now I stumbled upon this method, because one day I had to go out and my twist when it dries, so I just pinned them through them under a wig, and I found that this Method works, but you don't want to do that too often, because your hair does not dry underneath that wig cap, so you can use other twists or braids. However, I prefer to use braids with this method when my hair is dry, because it lays down a lot flatter now, with the front half of your hair you're, going to start by making a clean part down the center of your head and clipping off one half Of your hair, now I'm going to make another part where I would normally have a side part for my wigs, and this is the part that really makes this pattern versatile, so that you can wear a wig with any kind of part with this method. So you're going to clip off that top half and work with the bottom half first and you're just going to repeat the same steps as before as far as putting in the product and detangling, and here you can also add in a little bit of gel, to Lay your edges, if you prefer to lay them before you braid now you want to make sure that the braid is loose at the root, but you by braiding away from your face this way. When you pin it, it will lay down a lot flatter on the sides. Now, when you braid the top half, you also want to make sure this part is extra loose at the root. This way you can pin it whichever way you want to when it is time here, you can see me checking to make sure it's loose enough for me to pull it on the other side of my head and you're, just going to repeat this same process on The other front, half of your hair, remember to braid loose at the root and make sure the bottom half is a way from your face and the top braid is extremely loose at the root, and this is what it should look like when it's all done. I'M checking my parts and making sure that I can move my braids when I need to. This is the braiding pattern I have in my head and now I'm taking some bobby pins and I'm just going to begin pinning these braids around my head, starting with the front so that the front lays extra flat. When I put on my wigs now the unit the first unit, I'm trying is a side part unit, so that is what I'm taking that other front half braid and I'm pinning it to the other side once that is all done. I put on my wig cap. Here'S where I normally put on my gel, but I'm not going to because tomorrow is wash day for me I'll, be sure to leave links to when I actually slide my edges with this method above and below now, I'm taking that curly unit that I had in My last wig review and I'm putting it on I'm making sure that my part and the wigs part match up so that it lays flat here's what it looks like from each side. Now I'm taking back off that wig cap to put on my next unit, this one is a straight unit and it is a middle part. So I'm moving that front braid to the other side and pinning it to the back. I'M putting back on my wig cap cleaning up my part before I throw the wig right back on here's, the wig, here's the center part, and now I'm just putting it on matching up my part just like I did the other way inserting mind combs and now I'M going to brush the wig out, so here is what the side views look like when I'm all done and yeah it's pretty much it for this video guys. I really hope you enjoyed don't forget to give it a big thumbs up and I'll see you in the next one.