How To Glue Hand Tied Wefts Together By Vision Hair Extensions

In this video we'll be showing you our method of measuring and gluing together, three hand-tied wefts for beaded row application. After all, your beads are applied dot. The scalp with a marker about a quarter of an inch in front of the first bead hold up. One of your bottom left from dot-to-dot along the beads mark on the left, where your row will end. This is where you'll cut the bottom to wefts trim the loose strings on the ends of all your webs. If your webs are curled up from being wrapped, you can use a straightening iron across the top of them to flatten em out find the mark you put on the wefts used for measuring and cut the excess weft off on the top left apply a thin bead Of Bandhu weave glue do the same with the weft. You just cut flip the cup weft and apply glue side down to the center of the longer weft, leaving a bit of overhang on each side, cut the next weft to the same length as the first. You can use these extra pieces, like we do here on the next layer for added thickness in the back and to not waste any hair, make sure when applying the bandha we've blue, you put the glue on both webs and press. The blue sides, together repeat the gluing process, with your last trimmed weft, also keeping it centered. Don'T worry too much about the wefts, aligning it's okay, if they overlap. This can make the weft a little thinner in the end. Finally, apply glue to the web sets overhanging fold that over to give you a secure, end, use your flat iron to get a strong seal. Repeat this on both sides: Sealand flatten the weft with your iron and your weft - is good to go thanks for watching like and subscribe for more hair extension videos visit us at vision, hair extensions com for all your hair extension needs.